Bosch Hot Water Heater Fault or Error Code EE Troubleshooting Guide
Is a Bosch fault code EE flashing on the digital monitor of your hot water temperature controller? The Bosch error code EE signifies that the modulating solenoid valve within the hot water unit has become disconnected.
In the event of an EE error code display in relation to your Bosch continuous flow hot water heater you may also experience no hot water.
The solenoid modulating valve regulates the pressure and temperature by allowing the gas to flow within the unit.
The Bosch continuous flow hot water heaters are built using advanced technology which has been developed with over 127 years of experience in the hot water industry. If you opted to have the hot water temperature controller installed with your Bosch hot water heater then you will have access to these fault codes should any issue arise within the system. The Bosch fault self-diagnosis feature is extremely handy in allowing for a fast repair and for the problem at hand to be identified immediately.
Bosch EE error code troubleshooting
If the Bosch EE fault code is flashing on your continuous flow hot water controller then you can attempt to turn the monitor off and then on again to test if it was a just a trip of the system. If the EE error code remains then you will need to call a fully qualified plumber to investigate the cause and either re-connect the solenoid modulating valve or replace the part if it has become faulty.
For a Bosch hot water heater repair expert you can’t go past the professional team from Jim’s Plumbing. We understand all Bosch fault code displays and how to rectify all issues with a fuss-free and affordable plumbing service.
No matter where you are – should you need a plumber in Adelaide, Melbourne, Perth, Sydney, Brisbane or Canberra then a local and experience Jim’s plumber will be at your door on the very same day of your plumber booking. We never leave our customers waiting days for a plumber to arrive and, in a gas or plumbing emergency, you can expect to see our plumbing van pulling into your driveway within only an hour* of your call – 24/7. We also have a plumber available to you on all public holidays.
For a prompt and reliable Bosch EE fault code resolve you can trust go past our service.
Preventative maintenance for your hot water heater
When was the last time that your hot water heater was serviced?
Your Bosch continuous flow hot water heater should undergo a service and safety inspection every two years. Hot water heater servicing will greatly reduce the risk of faults and error code displays on your hot water heater, including the Bosch EE fault code.
To arrange a hot water heater service inspection call the friendly team from Jim’s Plumbing. Preventative maintenance of your appliance provides longer lasting durability and optimal performance from your hot water heater.
Call a fully qualified, insured and local plumber from Jim’s Plumbing today on 1300 133 509 (SA, VIC, WA) or 131 546 (NSW, QLD, ACT).
Why not have us call you at no cost to you? Just complete our easy online plumber booking form.
No Interest Ever!* Payment Plan Options Available
No Interest Ever!* payment plan options available on hot water heater replacements to help ease any financial stress this burden may cause. If your bosch hot water heater is leaking, or you have no hot water, we can often have a plumber to you within the hour*.
*NO INTEREST EVER!* PAYMENT PLAN, “Fees, terms and conditions apply”.
No Interest Ever!* Payment Plan offered through Certegy Ezi-Pay Express. No Interest Ever on your hot water heater replacement or new supply and installation, gas service, water service or drain replacement. Conditions apply.
Information on this page is subject to change. Commercial hot water systems also available on enquiry.