Bosch Hot Water Heater Fault or Error Code CF Troubleshooting Guide
Bosch hot water heaters are available with an optional water temperature controller. The temperature controller is an excellent feature allowing you to pre-set your hot water temperature for different areas within your home.
With a pre-set temperature setting all you need to do is turn on only the hot tap and once your desired setting has been reached that is where it will stay – providing convenience, safety and comfort.
Another advanced feature of the temperature controller is its ability to self-diagnose any fault within the hot water heater. If a fault is detected a certain code will flash on the status monitor alerting you to take action before the problem has time to escalate.
Is a Bosch hot water heater fault code CF blinking on the digital monitor of your hot water temperature controller? If so, this is an indication that there is a blockage, or a build-up of dirt, in the flue gas outlet.
The flue gas outlet is required to vent gas wastage and to prevent dangerous fumes from entering your home. Flueing also increases the effectiveness of the hot water heater. It is an extremely important safety feature of a gas hot water unit and any issues will be required to be attended to upon first signs.
Bosch error code CF troubleshooting– Continuous flow hot water
You can attempt to clear the Bosch fault code CF (in the event that it has displayed in error) by turning the hot water system off at the main power, opening a hot water tap fully and then turning the appliance power back on. If the error code CF is still flashing on the digital monitor of your temperature controller then it is time to call a fully qualified service technician.
Who should you call for a fast Bosch CF error code repair?
Call in a reliable, friendly and affordable plumber from Jim’s Plumbing. We can have the CF error code cleared and your hot water heater back in normal functioning order on the same day as your plumber booking.
Your attending plumber from Jim’s will inspect your Bosch gas hot water heater to check for any dirt or debris that may be blocking the flue gas outlet, and clean and clear as required. If no dirt build up is present they will check the connections within the system to ensure there are no loose or damaged parts leading back to the electronic control unit. If any replacement parts are required, in most cases, your Jim’s plumber won’t need to leave site to source as they come to you in a fully stocked van.
You can trust that your plumber from Jim’s is fully qualified and is an expert at Bosch hot water heater repairs. The hot water fault code CF will be rectified in an efficient and prompt manner allowing your hot water to be running hot again before you know it.
With our same day plumbing service, or within the hour* in a gas or plumbing emergency, you can rely on a local plumber from Jim’s Plumbing – available 24/7, including all public holidays.
We cover all metropolitan areas of Adelaide, Melbourne, Perth, Brisbane, Sydney and Canberra.
So don’t delay – pick up the phone and call 1300 133 509, or complete our online plumber booking form and receive an instant call back at no cost to you.
No Interest Ever!* Payment Plan Options Available
No Interest Ever!* payment plan options available on hot water heater replacements to help ease any financial stress this burden may cause. If your bosch hot water heater is leaking, or you have no hot water, we can often have a plumber to you within the hour*.
*NO INTEREST EVER!* PAYMENT PLAN, “Fees, terms and conditions apply”.
No Interest Ever!* Payment Plan offered through Certegy Ezi-Pay Express. No Interest Ever on your hot water heater replacement or new supply and installation, gas service, water service or drain replacement. Conditions apply.
Information on this page is subject to change. Commercial hot water systems also available on enquiry.